Skip to content
EN
  • Español
  • English
Advertisement

Cutting speed and RPM calculator

Work out spindle speed (rpm) from cutting speed and diameter, or the cutting speed from the rpm. For lathe turning, milling and drilling.

Fill in 2 of the 3 fields and the missing one is calculated. You can type in any of them.

It depends on the material and the tool. See the table.
Of the workpiece when turning; of the tool when milling and drilling.

Use this calculator for reference only, as we cannot guarantee that the results are free of errors.

Disclaimer

https://dyaii.es/en/cutting-speed-rpm-calculator/

Advertisement

The right spindle speed depends on the cutting speed the material allows with your tool and on the diameter that rotates. Give two of the three values and the calculator works out the third.

How to use the calculator

  1. Choose the recommended cutting speed for your material and tool.
  2. Enter the diameter: the workpiece on the lathe, the tool on a milling machine or drill.
  3. You get the spindle speed. You can also enter the rpm to find out the cutting speed you are working at.

Spindle speed formula

n = (Vc · 1000) / (π · D)

Where n is the speed in revolutions per minute, Vc the cutting speed (m/min) and D the diameter (mm). The 1000 converts meters to millimeters.

Vc = (π · D · n) / 1000
Advertisement

Worked example

Turning a 50 mm steel shaft with a carbide insert at 200 m/min:

n = (200 · 1000) / (3.1416 · 50) ≈ 1273 rpm

On the machine you set the closest available value, for example 1250 rpm.

Typical cutting speeds

MaterialHigh-speed steel (HSS), m/minCarbide, m/min
Carbon steel25 – 35150 – 250
Stainless steel10 – 2080 – 150
Gray cast iron15 – 2580 – 150
Brass50 – 80150 – 300
Aluminum60 – 150300 – 800
These are starting values. The tool manufacturer gives the exact speed for the insert, the coating and the operation.
Advertisement

Frequently asked questions

Which diameter do I use on the lathe?

The workpiece diameter where you are cutting. When facing, the diameter changes all the time; that is why CNC lathes use constant surface speed (G96) with a spindle speed limit.

And on the milling machine or the drill?

The diameter of the tool (end mill or drill bit), because the tool is what rotates.

What happens if the cutting speed is too high?

The tool heats up and wears much faster. If it is too low, the surface finish gets worse and some materials form a built-up edge.

Share

WhatsApp X LinkedIn Telegram Email
Advertisement

Install Diseño y automatización de instalaciones industriales on your phone

All the calculators one tap away, full screen, like an app. It takes no space and is always up to date.