Electricity
Power, current, voltage drop, cable size and power factor.

Battery life calculator (Ah, Wh and Peukert)
Calculate how long a battery lasts with a load in amps or watts, or the capacity you need. With depth of discharge, inverter, Peukert and Ah to kWh.

Voltage drop calculator and wire size
Calculate the voltage drop of a cable in three-phase, single-phase or DC, the minimum wire size under Spain's REBT limits and the maximum length.

Capacitor to run a three-phase motor on single-phase power
Size the capacitor to run a three-phase motor on single-phase power (Steinmetz connection): capacitance in µF from the motor power, or the other way.

Delta to wye (Δ-Y) conversion calculator for resistors and impedances
Convert three resistors or impedances from delta to wye and from wye to delta (Kennelly’s theorem), with a drawing of both connections.

Power factor correction calculator: capacitor bank sizing in kVAR and µF
Size the capacitor bank to improve your power factor: kVAR, µF per capacitor in delta or wye, current before and after, and the kVA you save.

Cable tray bend and offset calculator
Cable tray bend calculator: cut table, formulas and marking dimensions for horizontal and vertical bends and offsets, step by step and in PDF.

kW to amps calculator: three-phase, single-phase and DC current
Three-phase, single-phase and DC current calculator: the amps a load draws from its power in kW, or the power from the current.

Short-circuit current calculator (low voltage)
Calculate the maximum short-circuit current at the transformer terminals and at the end of the line, the minimum phase-neutral fault and breaking capacity.

Ohm's law calculator: voltage, current, resistance and power
Calculate voltage, current, resistance or power from any two values, plus the energy lost as Joule heating. With the Ohm's law wheel of formulas.

Wire resistance calculator: resistivity, length and cross-section
Calculate the resistance of a wire or conductor from its material, length, cross-section and temperature. Also solves for the length or the wire size.

Earth resistance calculator: ground rods, ring and grid
Calculate the resistance of an earthing system with ground rods, buried conductor, ring, plate or grid (ITC-BT-18), the rods you need and the RCD check.

Electric motor calculator: current, power, voltage, power factor and efficiency
Calculate the current of a three-phase, single-phase or DC electric motor from its power, voltage, power factor and efficiency, or the missing value.

Electrical power calculator: active, reactive and apparent power and power factor
Power triangle calculator: active, reactive and apparent power, cos φ, voltage and current in three-phase, single-phase or DC from any three values.

Reactance, impedance and resonant frequency calculator for RLC circuits
Calculate inductive and capacitive reactance, impedance, phase angle, current and resonant frequency of a series or parallel RLC circuit.

LED resistor calculator (and Zener diode)
Calculate the resistor for one or more LEDs in series: value, power rating and standard E12 or E24 resistor with its real current. Also for a Zener diode.

Series and parallel resistor calculator (and capacitors)
Calculate the equivalent resistance of up to 7 resistors in series or parallel, or the capacitance of capacitors. Also the value missing for a total.

RMS, peak, peak-to-peak and average value calculator
Calculate the RMS, peak, peak-to-peak and average values of a sine, square or triangle wave, for voltage or current, from just one of them.

Motor speed calculator: synchronous speed and slip
Calculate the synchronous speed of a motor from the frequency and number of poles, and its slip from the actual speed. Also the other way: rpm or Hz.

Voltage divider calculator (and current divider)
Calculate the output of a voltage divider, or the missing resistor or input voltage. Also the current divider, the current and the power of each resistor.

Transformer calculator: turns ratio, voltages and full-load current
Calculate the ratio of a single-phase or three-phase transformer: primary and secondary voltages, number of turns and rated (full-load) currents.

Resistor color code calculator: 4, 5 and 6 bands
Find the value of a resistor from its color bands (4, 5 or 6) or the colors for a value, with tolerance, min, max and E series. Inductors too.

AWG to mm² converter: wire gauge, cross-section and diameter
Convert an AWG wire gauge to mm² and diameter, or the other way around, from 4/0 to AWG 40, and get the nearest standard metric size. With a full chart.

Circuit breaker size calculator: choosing the breaker or fuse for a cable
Choose the circuit breaker or fuse rating that protects a cable: Ib ≤ In ≤ Iz and I2 ≤ 1.45·Iz (UNE-HD 60364-4-43, ITC-BT-22), or the cable's minimum Iz.
