Support spacing calculator: distance between supports
Space supports evenly along a run: get the spacing for a given number of supports, or how many you need to stay under a maximum support spacing.
When you install a cable tray, a pipe or a profile you have to space the supports along the run. This calculator gives you the spacing between supports for a given number of supports or, the other way round, how many supports you need so as not to exceed a maximum spacing.
How to use the calculator
- Choose the layout: with your own distances at the ends (C and D) or all equally spaced.
- Enter the total length and the number of supports: you get the spacing.
- If you type the maximum spacing allowed by the manufacturer, it works out the supports needed (rounding up) and the actual spacing.
Formulas
With custom end distances:
If everything is equally spaced, the ends are the same as the spacing between supports:
Worked example
A 6 m run with the first and last supports 250 mm from the ends and a maximum spacing of 1.5 m:
With 5 supports the actual spacing is 1375 mm.
Maximum spacing
The maximum spacing depends on the type of tray or pipe, its material and the load. Always check the manufacturer's table or the applicable standard; as a guide, cable trays are usually supported every 1.5 to 2 m.
Frequently asked questions
Why is it rounded up?
So as not to exceed the maximum spacing: if you get 4.67 supports you need 5; with 4 the spacing would be more than allowed.
Are the end supports counted?
Yes: n is the total number of supports on the run.
