Skip to content
EN
  • Español
  • English
Advertisement

Resistor to convert 4-20 mA to voltage (Ohm’s law)

Calculate the resistor that converts a current signal (4-20 mA, 0-20 mA) to voltage (0-10 V, 1-5 V…) for an analog input, using Ohm’s law both ways.

Fill in 2 of the 3 fields and the missing one is calculated. You can type in any of them.

Voltage at 4 mA (signal zero)—
Power dissipated—

Use this calculator for reference only, as we cannot guarantee that the results are free of errors.

Disclaimer

https://dyaii.es/en/4-20-ma-to-voltage-resistor/

Advertisement

Many analog inputs only accept voltage. To read a 4-20 mA signal, all you need is a resistor in parallel with the input: the current flowing through it creates a proportional voltage. This calculator applies Ohm’s law to get the resistance, the voltage or the current.

How to use the calculator

  1. Enter the maximum current of the signal (20 mA) and the maximum voltage of the input (for example, 10 V).
  2. You get the resistance you need, the voltage you will have at 4 mA and the power it dissipates.
  3. You can also type the resistor you have and find out what voltage it will give.

Formula: Ohm’s law

R = V / I

With V in volts and I in amps, R comes out in ohms: 10 V / 0.020 A = 500 Ω.

Advertisement

Common resistors

SignalInputResistorResulting voltage
4-20 mA0-10 V500 Ω2-10 V
4-20 mA0-5 V250 Ω1-5 V
0-20 mA0-10 V500 Ω0-10 V
0-20 mA0-5 V250 Ω0-5 V
With 4-20 mA the voltage does not start at 0: with 500 Ω it goes from 2 to 10 V. Scale the input from 2 to 10 V in the PLC.

Which resistor to buy

Use a precision resistor (0.1 % or better) with a low temperature coefficient, because its error goes straight into the measurement. The power is very low (200 mW with 20 mA and 500 Ω), but it should be rated for at least 0.5 W.

Advertisement

Frequently asked questions

Is it wired in series or in parallel?

In parallel with the voltage input and in series with the current loop: all the loop current flows through the resistor.

Does it affect the transmitter?

The resistor adds load to the loop. Check that the power supply has enough voltage: with 500 Ω and 20 mA it needs 10 V for the resistor alone, plus whatever the transmitter requires.

Related calculators

Share

WhatsApp X LinkedIn Telegram Email
Advertisement

Install Diseño y automatización de instalaciones industriales on your phone

All the calculators one tap away, full screen, like an app. It takes no space and is always up to date.