Cable sag and catenary calculator: tension, sag and length
Work out the sag of a cable or power line between two supports from the span, weight per metre and tension, or the tension for a sag, with the cable length.
A cable hanging between two supports (a power line, a fibre run, a tent guy or a zip line) does not stay straight: it sags under its own weight and forms a curve called a catenary. The tighter it is pulled, the less it sags, but the more force the supports carry. The calculator gives the sag from the tension, or the tension for a sag, the cable length and the tension at the supports.
Formulas
a is the span, w the weight per metre (plus any ice or wind load), H the horizontal tension (the same along the whole cable) and T the tension at the supports, slightly higher. Example: ACSR 0.433 kg/m (w = 4.25 N/m), 100 m span and 4 kN: f = 1.33 m, S = 100.05 m and T = 4.006 kN.
Catenary or parabola
When the sag is small compared to the span (under 5 %), the parabola gives almost the same answer and is easier to solve: H = w · a² / (8f). For large sags (a slack cable, a deeply sagging zip line) you need the catenary, which is what the calculator uses.
Several ways to get each value
- The sag from the stringing tension.
- The tension for a desired sag (for instance, the one that keeps the minimum ground clearance): enter the sag and clear the tension.
- The maximum span for a tension and a sag: clear the span.
- The actual weight of a cable by measuring its sag at a known tension (load cell): clear the weight.
What a real line needs
- Overhead line standards set the load cases: temperature, wind and ice depending on the zone, and minimum ground clearance.
- Maximum sag comes with heat (the cable stretches) or ice; maximum tension, with cold plus wind or ice.
- Tension should not exceed about a third of the cable breaking load in everyday conditions.
Frequently asked questions
How is cable sag calculated?
With the catenary: f = H/w · (cosh(w·a / 2H) − 1), with H the horizontal tension, w the weight per metre and a the span. For small sags the parabola f = w·a² / (8H) works. An ACSR 0.433 kg/m on a 100 m span at 4 kN: about 1.33 m.
What tension is needed for a given sag?
Enter the sag and clear the tension. The tighter, the less it sags, but tension rises fast: halving the sag needs twice the tension.
How much cable is needed between two poles?
A bit more than the span: S = 2H/w · sinh(w·a / 2H). With 100 m and 1.33 m of sag, about 100.05 m. Roughly, S ≈ a + 8f² / (3a).
What is a catenary?
The curve a flexible cable forms when hanging from its ends under its own weight: y = c · cosh(x / c), with c = H / w. It looks very much like a parabola when the sag is small compared to the span.
