Mitre angle calculator for frames and polygons
Work out the mitre cut angle for the pieces of a frame, a hexagon or another polygon, or for a corner of any angle, and what to set on the mitre saw.
A mitre joint cuts the two pieces that form a corner at the same angle, so they meet without showing the end grain. In a square frame it is 45°, but in a hexagon, an octagon or a wall corner that is not square it changes. The calculator gives the cut angle from the number of sides or the corner angle, and the outside length of each piece.
Formulas
α is the interior corner angle and n the number of sides. Each piece is cut at α/2 to its edge, which on the mitre saw scale (where 0° is a square cut) is 90° − α/2. When cut, the outside edge is longer than the inside one:
Angles of common polygons
| Sides | Corner | Mitre saw | Cut from the edge |
|---|---|---|---|
| 3 (triangle) | 60° | 60° | 30° |
| 4 (frame) | 90° | 45° | 45° |
| 5 (pentagon) | 108° | 36° | 54° |
| 6 (hexagon) | 120° | 30° | 60° |
| 8 (octagon) | 135° | 22.5° | 67.5° |
| 12 | 150° | 15° | 75° |
Several ways to get each value
- From the number of sides: frames, planters, gazebos, hexagonal tables.
- From the corner angle: skirting boards and mouldings on walls that are not square. Measure the angle, enter it and clear the number of sides.
- The number of sides for an angle: handy to know how many pieces close a circle.
- The cut length: enter the inside length you want and the width of the strip.
Cutting tips
- Cut a test piece first: a 0.5° error in an octagon is multiplied by 16 cuts and leaves a gap.
- Crown mouldings that sit tilted against the wall need a compound mitre: cut angle and bevel at the same time.
- On skirting boards, for inside corners a coped joint is better than a mitre: it does not open if the wall moves.
Frequently asked questions
What angle do you cut for a hexagon?
Each corner is 120°, so each piece is cut at 60° to its edge, which on the mitre saw is 30° from square (180° / 6).
What is the mitre formula?
For an n-sided polygon, the mitre saw angle is 180° / n: 45° for a 4-sided frame, 30° for a hexagon, 22.5° for an octagon. For a corner of α degrees, (180° − α) / 2.
How do you cut a corner that is not 90°?
Measure the wall or corner angle with a sliding bevel or angle finder, divide it by two and cut each piece at that half from its edge. Enter the angle and the calculator gives the mitre saw setting.
How long should each frame piece be?
The outside is the inside plus 2 · width · tan(mitre saw angle). In a 4-sided frame with a 40 mm strip, the outside is 80 mm longer than the inside.
