True position: deviation, maximum material and bonus tolerance
Work out the true position of a hole or shaft from the measured X and Y deviations, the bonus tolerance at maximum material condition (MMC) and whether the part meets the drawing.
A position tolerance states how far the centre of a hole, shaft or pin may move from its theoretical location, the one given by the basic (boxed) dimensions on the drawing. The allowed zone is a circle (⌀) centred on that location. Measuring the part on a coordinate measuring machine or on the bench gives the deviations in X and Y; the calculator turns them into true position and tells whether it passes.
True position formula
Δx and Δy are the differences between the measured and the theoretical centre. It is multiplied by 2 because the drawing tolerance is a diameter, not a radius. Example: Δx = 0.03 mm and Δy = 0.04 mm: TP = 2 · 0.05 = 0.10 mm. With ⌀0.08 and no modifier, it fails.
Maximum material: the bonus tolerance
With the Ⓜ symbol after the tolerance (ISO 2692), the tolerance applies to the feature at maximum material: the smallest hole or the largest shaft its size allows. If the hole comes out larger, the bolt has more clearance and the hole may shift further and still assemble: that difference is added. In the example, a ⌀10 +0.1/0 hole measured at 10.05 adds 0.05: the tolerance becomes ⌀0.13 and the part passes, using 77 %.
| Modifier | Hole | Shaft |
|---|---|---|
| No modifier (RFS) | The drawing tolerance, no bonus | |
| Ⓜ maximum material | + (measured d − minimum d) | + (maximum d − measured d) |
| Ⓛ least material | + (maximum d − measured d) | + (measured d − minimum d) |
Round zone versus ± dimensions
If the drawing used ± in X and Y, the zone would be a square. The square inscribed in a ⌀0.1 circle is ±0.035 mm, and the circle has 57 % more area: position accepts parts that ± would reject, with no effect on assembly.
Several ways to get each value
- True position: from the X and Y deviations.
- How far one axis may deviate knowing the other: Δx = √((t / 2)² − Δy²).
- With polar coordinates (radius r from the theoretical centre): TP = 2 · r.
- For a hole pattern: each hole is checked against its own theoretical location and the worst one counts.
Standards: ISO 1101 (geometrical tolerancing), ISO 2692 (maximum and least material) and ASME Y14.5.
Frequently asked questions
How is true position calculated?
It is the diameter of the circle centred on the theoretical location that passes through the measured centre: TP = 2 · √(Δx² + Δy²). With 0.03 mm in X and 0.04 in Y: 2 · 0.05 = 0.10 mm.
What is bonus tolerance?
With the Ⓜ symbol, the further the hole departs from maximum material (the larger it is), the more it may shift and the bolt will still fit. The difference between measured and MMC size is added: a 10.05 hole with a 10.00 minimum and ⌀0.08 Ⓜ allows ⌀0.13.
Why is the zone round and not square?
The round position zone gives 57 % more area than the inscribed ± square, and matches the function: the bolt must fit in any direction. A ⌀0.1 tolerance equals ±0.035 in X and Y.
Which standard covers position tolerance?
ISO 1101 (geometrical tolerancing) and ISO 2692 (maximum material requirement) in Europe, and ASME Y14.5 in the United States.
