Skip to content
EN
  • Español
  • English
Advertisement

Economic pipe diameter calculator

Calculate the economic diameter of a steel pipe from the flow rate and fluid density (Peters and Timmerhaus), or the flow rate for which a diameter is optimal.

Fill in 1 of the 2 fields and the missing one is calculated. You can type in any of them.

Mass flow rate—
Velocity with that diameter—
Reynolds number—
Fluid density—
Fluid dynamic viscosity—

Use this calculator for reference only, as we cannot guarantee that the results are free of errors.

Disclaimer

https://dyaii.es/en/economic-pipe-diameter-calculator/

Advertisement

Choosing a pipe diameter is a balancing act: a small pipe is cheap, but the pump uses a lot of energy to overcome the pressure drop; a large one uses little energy, but costs a lot to buy, support and insulate. The economic diameter is the point where the total cost is lowest. This calculator estimates it with the Peters and Timmerhaus formula.

How to use the calculator

  1. Choose the material (carbon or stainless steel) and the fluid. For a gas, enter its density at the pipe pressure.
  2. Enter the flow rate and you will get the economic inside diameter. Or the other way round: enter a diameter and you will know the flow rate for which it is the economic one.

Economic diameter formula

Carbon steel: d = 293 · G0.53 · ρ−0.37
Stainless steel: d = 260 · G0.52 · ρ−0.37

Where d is the optimum inside diameter (mm), G the mass flow rate (kg/s) and ρ the fluid density (kg/m³). These are the Peters and Timmerhaus correlations given by Coulson and Richardson (volume 6), for turbulent flow.

It is a starting estimate with average pipe and energy prices. If energy is very expensive or the installation runs many hours, it is worth going up one diameter.
Advertisement

Worked example

20 m³/h of water (ρ = 998 kg/m³) through a carbon steel pipe:

G = 20 / 3600 · 998 ≈ 5.544 kg/s
d = 293 · 5.5440.53 · 998−0.37 ≈ 293 · 2.479 · 0.0776 ≈ 56.4 mm

A DN 50 steel pipe (about 53 mm inside) or a DN 65 (about 70 mm). The velocity with 56 mm would be about 2.2 m/s.

Why density is in the formula

At the same mass flow rate, a less dense fluid takes up more volume and needs a larger diameter. That is why the density exponent is negative: gases give much larger economic diameters than liquids, although their velocity also comes out higher.

Advertisement

Frequently asked questions

What is the economic diameter?

The one that minimises the total cost of the installation over its service life: a larger pipe costs more to buy and install, but uses less pumping energy. The economic diameter balances the two costs.

Does it work for laminar flow?

No: the formula is for turbulent flow, the usual case with water and gases. With very viscous oils (laminar flow) the economic diameter comes out larger.

Do I have to use exactly that diameter?

No, it is a starting estimate. Choose the nearest commercial diameter and check the velocity and the pressure drop.

Related calculators

Share

WhatsApp X LinkedIn Telegram Email
Advertisement

Install Diseño y automatización de instalaciones industriales on your phone

All the calculators one tap away, full screen, like an app. It takes no space and is always up to date.