Skip to content
EN
  • Español
  • English
Advertisement

Pneumatic cylinder force calculator

Work out the extend (push) force of a pneumatic cylinder from the air pressure, the piston diameter and the efficiency, or the bore you need.

Fill in 3 of the 4 fields and the missing one is calculated. You can type in any of them.

Gauge pressure at the cylinder inlet.
Friction losses in the seals. Usually between 85 % and 95 %.
%
Piston area—

Use this calculator for reference only, as we cannot guarantee that the results are free of errors.

Disclaimer

https://dyaii.es/en/pneumatic-cylinder-force-calculator/

Advertisement

The force of a pneumatic cylinder depends on the air pressure and the piston area. You can get the force or, the other way round, the cylinder bore you need for a given force.

How to use the calculator

  1. Enter the working pressure that reaches the cylinder (usually 6 bar).
  2. Enter the piston diameter and the efficiency (90 % is typical).
  3. You get the extend force. If you leave the diameter empty and enter the force, it works out the minimum diameter.

Cylinder force formula

F = p · A · η  ·  A = π · D² / 4

Where F is the force (N), p the pressure (Pa), A the piston area (m²) and η the efficiency. In shop units: 1 bar = 100,000 Pa and the diameter in millimeters is divided by 1000.

Advertisement

Worked example

A 50 mm cylinder at 6 bar with 90 % efficiency:

F = 600,000 · (π · 0.05² / 4) · 0.90 ≈ 1060 N ≈ 108 kgf

Theoretical force by bore at 6 bar

Without efficiency losses (η = 100 %).

Diameter (mm)Extend force (N)
16121
20188
32483
40754
501178
631870
803016
1004712
Choose the next standard bore above the one the calculator gives you and leave a safety margin.
Advertisement

Frequently asked questions

Is the retract force the same?

No, it is lower. When retracting, the air pushes on the annular area of the piston: the piston area minus the rod area.

What safety margin should I allow?

Cylinders are usually sized with a theoretical force between 1.5 and 2 times the force needed, especially if there is friction or speed is important.

Which pressure should I use?

The pressure that reaches the cylinder while it is working, not the compressor pressure. Most installations work at 6 bar.

Related calculators

Share

WhatsApp X LinkedIn Telegram Email
Advertisement

Install Diseño y automatización de instalaciones industriales on your phone

All the calculators one tap away, full screen, like an app. It takes no space and is always up to date.